Retell.IT – 2013 – Faulty capacitor on Toshiba laptop

Speaking about faulty capacitors reminded me of a Toshiba laptop that I repaired in August 2013.  This Toshiba laptop belonged to a friend’s landlord – if my friend could get it fixed economically, he could score brownie points – always an advantage to be on good terms with your landlord, especially when the rental climate looks like rents are rising.

SONY DSC

This is with the laptop taken apart – see the massive amounts of dust in the cpu heatsink heat distributor and fan just above.  The laptop would fail to boot and from research on the internet, the cause was a failed capacitor – the rectangular NEC TOKIN inside that metal plate near the bottom left.  This capacitor was a bugger to remove – I tried Infrared heating – it just started to cook the plastic top and did not budge.  These are often glued down, but because it had a large contact area on the board, it was impossible to remove without more specialized equipment that I don’t have, i.e. dark infrared reworking station with under board heater and good temperature controller.

I had to effective destroy the capacitor piece by piece, layer by layer.  Actually capacitors are fragile and easy to destroy especially if I am wielding a scalpel.  Eventually it was removed, and I replaced it with four smd capacitors.  I had to use a fibreglass pen to remove the green coating from the board in order to do the soldering of the replacement capacitors.

SONY DSC

Now a closeup of the board with the replacement capacitors.  The motherboard was reassembled in the laptop, after cleaning all the dust, of course – then powered on, and it worked.  Total cost to the friend’s landlord was $60 plus a lot of brownie points.

[Note]  I have since learned that I could have used my existing infrared rework station by using the under board heater, then heating the capacitor with the infrared, and use my hot-air rework station to add additional heat – to keep the temperature steady.  But that comes with a risk of damage to the board due to the heat being there for much longer – my scalpel was much better.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s